Lunar Caravans ALARIA 2018, Handbook

Page: 108 / 146

108
THETFORD TOILETS
Preparing for use
This Cassette Toilet has a waste-holding tank
of 17.5L. Before using your toilet, it is vital
that you add toilet additives to these tanks.
Check the correct dosage on the additive
package. Then add
±
3L of water to the waste
holding tank.
Use of your toilet
Turning the bowl
You can turn this bowl to
a desired position (max
±
90
°
C). Close the cover
and use both hands to
rotate the bowl as
illustrated.
Opening the blade
The toilet can be used
with the blade open or
closed.
To open the blade, slide
the blade handle
sideways as illustrated.
Make sure you always
close the blade
completely after use.
Electric Blade (if applicable)
Press the flush button to activate the control
panel. Then push the Electric Blade button.
The blade will open or close electrically.
Flushing the toilet
Press the flush button
once to activate the
control panel. Then
press the flush button for
several seconds to flush
the toilet.
Electric Ventilator (if applicable)
By activating the control panel, the Electric
Ventilator will start automatically; it will shut
off automatically after about 5 minutes. The
Electric Ventilator button will flash to show
that this function is active. To stop the
ventilator, press the Electric Ventilator button.
Press the button again to re-start the
ventilator. To optimise its function, activate
the Electric Ventilator before you use your
toilet.
Ordinary toilet paper can cause clogging.
Use Aqua soft toilet paper instead. This toilet
paper is super-soft, dissolves quickly,
prevents clogging and makes it easier to
empty the waste-holding tank.
Level indication
You can check whether your waste-holding
tank has a 1-level or a 3-level indication.
Make sure the tank is empty and place it
back properly. Then activate the control
panel. If no level indication light lights up,
your toilet has a 1-level indication. It will only
indicate a full tank. If a green level indication
light immediately lights up, your toilet has a
3-level indication. It will indicate empty, half
full and full.
Emptying the tank
Waste holding tank
When the red light of the level indicator on
the control panel lights up, you need to
empty the waste-holding tank. Remove the
tank via the service door. Then take it to an
authorised waste disposal point. Empty the
waste holding tank via the pour out spout.
Tip: To empty the tank without splashing,
press and hold the vent button with your
thumb while the pour out spout is pointing
downwards.
Waste Pump-out system (if applicable)
By activating the control panel, this button
automatically lights up. Press the button to
empty the waste-holding tank into the
vehicle's central waste tank. The button
flashes while the waste is being pumped and
stops flashing when all waste has been
transferred. (
±
1.5L of waste is left). If the
central waste tank is too full (only measured
when this tank has a level indicator), the
button flashes rapidly and no pump-out is
possible until you have emptied the central
waste tank.