9
CХОКЧ КХХ tСО ЩКrts КММШrНТЧР tШ tСО КrtТМХО «CХОКЧТЧР КЧН ЦКТЧtОЧКЧМО».
Do not immerse motor unit into water.
Dry thoroughly before use.
USING THE APPLIANCE
ASSEMBLING
1.
Press the locking button, hold the head and insert into the inlet. When inserting please make sure that head must be slanted as per arrow indicated (fig.1), then move the head anticlockwise so the
head will be fastened tightly. (fig.2)
2.
Place the feeder screw into the head, long end first, and turn to feed the screw slightly until it is set into the motor housing. (fig.3)
3.
Place the cutting blade onto the feeder screw shaft with the blade facing the front as illustrated (fig.4). If it is not fitted properly, meat will not be grinded.
4.
Place the desired cutting plate next to the cutting blade, fitting into the slot. (fig.5)
5.
Support or press the center of the cutting plate with one hand then screw the fixing ring tight with another hand (fig.6). Do not over tighten. Place the food tray on the head and fix it into position (fig.7).
Locate the unit on a firm place. The air passage at the bottom and the side of the motor housing should be kept free and not blocked.
MINCING
1.
Prepare the meat to be minced. Remove any bones and gristle. Never use frozen meat!
2.
Cut the meat into pieces so that they easily fit the grinder head.
3.
Place a bowl for minced meat under the grinder head.
4.
Plug the unit in and switch ON/O/R button to ON position.
5.
Put the meat in the tray; use the pusher to gently push the meat into the grinder head body. Never push the meat down with your fingers.
6.
After you finish operating the unit, switch ON/O/R button to O position, unplug it.
REVERSE FUNCTION
If the meat gets stuck in the feeder screw during operation, use the reverse function to release the jam.
1.
Switch off the unit by switch the ON/O/R button to O position, wait until the motor stops completely. Then switch and hold down the switch ON/O/R button to R positon for 5-10 seconds.
2.
The feed screw starts rotating in the opposite direction and push out jammed food.
3.
If this does not help, unplug the unit from the outlet, dissemble and clean it.
