Lumberjack TS254SW, Safety And Operating Manual

Page: 14 / 34

TS254SW 12
Assembly Instructions
When the extension table is in the desired
position, the locking handle is in the “DOWN”
Position(See Fig. G4).
NOTE: Make sure the locking handle is locked
securely.
Screw the stopper on the extension rails
(See Fig. G5)
Elevating & lowering handle
Mount the blade elevation handle (13) on the
wheel by tightening the nut in the handle.
Mounting the rip fence
Release the locking handle by pulling it upward.
Mount the rip fence onto the table so that the side
with the indicator is on the scale side of the table
(See Fig. I1).
Start by sliding the front of the rip fence onto the
front side of the table so that the front locking
plate contacts the front side of the table then push
down on the back of the rip fence so that the
fence is level on the table. Be sure front and rear
locking plates are in contact with both the front
and back edges of the table.(See Fig.I2)
Unclipping the rip fence
Release via the locking handle