Lumberjack TS254SW, Safety And Operating Manual

Page: 12 / 34

TS254SW 10
Assembly Instructions
To transport the table saw
The upper legs may be locked in the vertical
position for use as a trolley handle.
Adjusting the splitter
The splitter(14) has two positions: storage
position (Fig. D1) and working position (Fig. D2).
The splitter is in the storage position when you
take it out of the package.
To place the splitter in the working
position:
– Remove the blade throat plate.
– Raise the blade up to the highest position by
turning the blade control wheel counterclockwise.
Set the bevel at 0°. Make sure the bevel is locked
tight.
– Release the splitter locking lever by pulling the
lever up.
– Pull the splitter up to the working position holes
should align with the two pins on the fixture.
– Lock the splitter by pushing the splitter locking
lever down.
NOTE: Make sure the splitter is locked securely.
– Place the blade throat plate back on.
To adjust the splitter to be in the storage
position:
Repeat steps 1 to 3 described above and slide the
splitter down to the storage position. Lock the
splitter locking lever. Lower the blade to the
lowest position. The splitter should be under the
saw table.
To adjust the height of the splitter
Loosen the two screws (a). Adjust the two
adjusting screws to make sure the splitter is about
1/8” (3mm) above the blade tips. Tighten the two
screws again.