LUDLUM 3030, Manual

Page: 22 / 79

Model 3030 & 3030E Series Technical Manual
Section 4
Ludlum Measurements, Inc. Page 10 November 2017
B-WN
: a multi-turn potentiometer used to vary the upper beta pulse
discriminator from
BT
setting to
AT
setting, normally set at 50 mV
B-TH
: a multi-turn potentiometer used to vary the lower beta pulse
discriminator from 2 to 15 mV, normally set at 4 mV
OL
: a multi-turn potentiometer that provides a means to vary the detector
current overload set point
HVL
: a multi-turn potentiometer used to calibrate the digital high voltage
HVM
: a multi-turn potentiometer used to manually adjust the high voltage
when digital control is not desired
Internal Controls
The following dipswitches and jumpers are located on the
amplifier/processor board and are only accessible when the cover is
removed.
Dipswitch 1
: When in the
OFF
position, the Model 3030 is locked into Scaler
mode only. The default position is
ON
.
Dipswitch 2
: When in the
ON
position, the calibration date is disabled. The
default position is
ON
.
HV Jumper
: When shunt is on the two outside pins, the HV is adjusted
manually with the HVM potentiometer. The normal shunt position is on the
two inside pins.