Ludlum Measurements 25024424, Manual

Page: 51 / 91

7.7. SETUP MENUS 47
ò
Range must provide at least two orders of magnitude between minimum and
maximum value.
Display Unit 1 RATE/MAX Mode Alert Point - Defines the value of the display unit 1 in RATE
or MAX modes. When this level is exceeded, the yellow LED will be on and alert tone will
sound.
This value should be above the minimum display value and below the maximum display
value. If an alarm is also enabled, the alert level should be below the alarm level. Set this to
000 to disable.
Configurable positions are:
• Ones Place (0-9)
• Tens Place (0-9)
• Hundreds Place (0-9)
• Decimal Point and Prefix (see previous table)
Display Unit 1 RATE/MAX Mode Alarm Point - Defines the value of the display unit 1 alarm
in RATE or MAX modes. When this level is exceeded, the red LED will flash, an alarm tone
will sound, and the ALARM icon will flash.
This value should be above the minimum display value and below the maximum display
value. If an alert is also enabled, the alarm level should be above the alert level. Set this to
000 to disable.
Configurable positions are:
• Ones Place (0-9)
• Tens Place (0-9)
• Hundreds Place (0-9)
• Decimal Point and Prefix (see previous table)
Display Unit 1 Count Units and Minimum Display - Sets the unit for COUNT mode as well
as the minimum displayable value (see Units on page 55). Since the range for minimum
display is dependent on the units, the setting is broken into two parts.
The first position that can be modified is the unit. While selecting the unit, the unit will be
the only thing on the screen.
Changing the next position will show the unit as well as 000 with a possible decimal point
and a possible prefix on the unit. Modifying this position will cycle through all available
decimal positions and prefixes.
June 2022