Ludlum Measurements 25024424, Manual

Page: 40 / 91

36 CHAPTER 7. CONFIGURATION
7.2 Setup Menu Introduction
The on device setup menu allows configuration through the three buttons on the front of the
device. Some setup functions require two types of button presses. A “
regular ” (short) press
is the normal momentary press and release of the button. A “ long ” press is a press and hold
for approximately one second before releasing. A short button press can be identified by a
dot next to the button icon (See figure 7.1a) A long button press can be identified by a dash
next to the button icon (See figure 7.1b)
(a) Short Button Press (b) Long Button Press
Figure 7.1: Button Press
7.3 Entering Setup Menu
To enter the setup menu:
1. Power down the instrument.
2. Turn the instrument back on.
3. Following the display of the battery voltage, when the instrument has begun normal
operation, press the MODE button three times (within four seconds) to enter the setup
menu
.
Entry to the setup menu can be confirmed when the display shows “dEt”, indicating the first
setup group is selected.
7.4 Entering Setup Menu (Alternative)
This device can be configured to quickly enter the setup menu. Lumic Calibration software
is required to enable this feature, but once the “Setup Menu Shortcut” is enabled, it can be
accessed at any time.
To enter setup mode through the quick access method, long press the UNIT and MODE but-
tons (see figure 7.2). The last accessed setup group will be displayed. All other functions of
setup mode will be normal.
Figure 7.2: Menu Short Cut
Ludlum Measurements, Inc.