Lucent 5ESS DRM, User Manual, Page: 371 / 642

7.1.3 Load TOP, AM Text, and AM ODD from Multi-Volume Formatted Backup
Tapes
OVERVIEW
The steps in this procedure loads AM text first; then if needed, loads the AM ODD. A
multi-volume DAT should contain all of the software media needed to dead start the
office (TOP, AM text, and AM ODD logical volumes).
PROCEDURE
1. Switch to the MCC by holding down the Ctrl key and pressing Enter (not Return)
key.
Load the backup tape.
2. In the following step, select the first configuration from Table 7.1.3-1.
Table 7.1.3-1 — Configurations for Dead Start
No. Configuration to Enter Configuration
1 20,30,33 CU0 MHD0 Pri Disk
2 22,30,33 CU0 MHD1 Sec Disk
Note: If the tape loading fails the initial loading, try rewinding the tape and
entering another 55 . If the tape operation continues to fail, take action described
in 235-600-601, Process Recovery Manual , and/or seek technical assistance .
3. Enter the EAI page commands for the selected configuration from Table 7.1.3-1.
Response: Disk indicators are SET,
Backup indicator is SET,
Min Config indicator is clear.
4. Obtain the latest AM ODD and AM text backup tape.
5. Mount the DAT backup that contains AM text into the tape drive.
6. On EAI page, type and enter: 55 .
7. Did the EAI Page respond with one of the following:
Boot? (y/n) or
BkRt Set! Boot (y/n) ?
If YES , then type and enter y and continue with the next step.
If
NO
, then continue with the next step.
8. If the response is ignored , enter 55 again.
9. Response:
DAT moves.
PRM_0 E151 33xx EEEE EEEE hh hh hh displayed on EAI page (when completed
and DAT tape rewinds).
Note: PRM_0 F0da zz00 0000 0000 xx xx xx (Where zz = 27, 28, 29, 2A)
Indicates a bad TOP tape.
235-200-150
January 2003 SYSTEM RECOVERY
Procedure 7.1.3
Issue 3.00 Page 7.1.3-1