Lucent Technologies PARTNER Endeavor 362, Programming And Use Manual

Page: 168 / 407

Direct Extension Dial Button (#113)
5-69
Considerations
■
The Automatic System/Direct Extension Dial PC card is purchased
separately and must be installed (see the
PARTNER PC Card Installation
Instructions .
■
Use the Direct Extension Dial Record/Playback to record a message
before using Direct Extension Dial since there is no default message.
■
It is recommended that you use only one automated answering option for
incoming calls (either this feature, the Automated Attendant Service of the
voice messaging system, or a PARTNER Attendant).
■
Direct Extension Dial does not transfer calls to Calling Groups.
■
This feature can handle three outside calls simultaneously.
■
If you have lines programmed for Direct Extension Dial and Automatic
System Answer, Direct Extension Dial answers the call first.
■
A Direct Extension Dial button must be programmed on a button with lights
on the system display phone at extension 10. (This feature will not work if it
is programmed on a button without lights.)
Valid Entries
1 = Assigned
2 = Not Assigned
✔
3 = Select button (then press a programmable button to assign Direct Extension
Dial to that button)
Programming
(See Figure 2-2 on page 2-19 for the location of special programming buttons
such as
s
and
e
on system phones.)
To assign or unassign a Direct Extension Dial button with lights at extension 10:
1. Press
f 0 0 s s # 1 1 3
.
2. If you want to assign Direct Extension Dial to the first available button,
press
D
until the following appears on the display:
DXD Button
1 Assigned-Ext10
If you want to unassign Direct Extension Dial, press
D
until the
following appears on the display:
DXD Button
2 Not Assigned