Chapter 6 Configuring Interfaces Using the AQueView EMS
Copying an Interface Configuration
6-12
255-700-467
PacketStar
®
PSAX 4-Port Voice 2-Wire Office Module User Guide
, Issue 1
Release 9.0.0
Copying an Interface Configuration
The Copy button on each Interface Configuration window allows you to
copy an interface configuration to a range of channels, either from a given
module, or for a range of modules
1
.
To copy an interface configuration to a range of channels, perform the steps
in the following procedure from the appropriate Interface Configuration win-
dow.
Begin
1
In the Interface Configuration window, click Copy
.
The Copy Interface Configuration window appears with the slot, port,
and channel of the interface you selected in the Start At: and Stop At:
panels (see Figure 6-3). Select the range of channels to which you wish
the interface configuration to be copied in the Slot, Port, and Channel
fields as follows (refer to Figure 6-4):
In the Start At panel, choose the slot and port where the copying should
begin. In the Stop At panel, choose the slot and port where the copying
should end.
2
To overwrite the pre-existing interface configuration, click the box beside
Overwrite configured interfaces.
Note:
“Overwrite” means that the existing interface will be deleted and a
new interface will be created in its place. To overwrite the interface
specified in the Stop At column, it must be out of service. The Dis-
able traps during copy option is enabled by default.
3
Click Copy.
The interface configuration is copied to the range of channels you
selected.
4
Click Close.
End
1
If you are copying a port configuration from an I/O module with only one port, you
must select different slot numbers in the Start At and Stop At panels.
