2
Locate the Phantom/Auxiliary power jumpers. Verify the power
jumper settings for your given configuration.
!
WARNING: If any of the jumpers
are not set correctly, they must be
set by a qualified technician.
d
Verify that the power jumpers are set to AUX (auxiliary).
3
Slide the cover upward (covering the power and terminating resistor
jumpers) until the line jack and adjunct jack are visible.
DESKTOP INSTALLATION
NOTE:
The following instructions describe the installation of the 8528T
voice/data terminal on a desk or table.
Use the following directions to connect the line cord and adjunct cord to
the appropriate jacks on the voice/data terminal.
1
Place the voice/data terminal face down on a flat surface.
2
Snap one end of the 7-foot line cord into the ‘‘LINE’’ jack and the
adjunct cord (if applicable) into the ‘‘ADJUNCT’’ jack on the bottom of
the voice/data terminal. Thread each cord through the routing
channel, making sure the cord fits under the square tabs. See
Figure 7 for the location of the jacks. For more information on
installing adjuncts, refer to the section ‘‘Attaching Adjunct
Equipment.’’
WARNING:
Correct cord types must be used when connecting
terminals and associated components. Failure to use the correct
cord and/or to properly insert the cord into the jack may cause
voice/data terminal malfunction or equipment damage.
3
Snap one end of the coiled cord into the Handset jack (marked with
the handset symbol) on the bottom of the voice/data terminal, as
shown in Figure 7. Thread the handset cord through the handset
cord routing channel.
WARNING:
Do
not insert the handset cord into the ‘‘ADJUNCT’’ jack.
It will cause equipment damage.
78
