Lucent Technologies 4ESS SCS, Maintenance Manual

Page: 500 / 526

234-151-077AC DLP-572
1999 June 7, Issue 4 of 2 Page
removing by packs circuit the of top the across stretches that bar hold-down the Remove 8.
bar. the lifting and bar the of end the at screw the
removed. be to packs circuit the of back the from screw holding the Remove 9.
of location slot the note to sure being packs, circuit appropriate the remove and up Lift 10.
packs circuit (The removed. is that pack circuit each must same the in later replaced be
removed. were they which from locations
sensor(s). current desired the remove and up Lift 11.
shown as correct are sensors current the of underside the on settings switch the that Verify 12.
2. Figure in
to them change 2, Figure in shown as correct not are settings switch sensor current the If 13.
settings. correct the
removed. were they which from positions same the into sensor(s) current the Reinsert 14.
position. into seated fully are sensor(s) current the that Ensure 15.
they which from slots same into 10 Step in removed were that packs circuit the Reinsert 16.
removed. were
slot. correct the into seated fully is pack circuit each that Ensure 17.
pack. circuit each of back the at screw holding the Replace 18.
packs. circuit the of top the across bar hold-down the Replace 19.
connections the that sure being 8, Step in removed was that cable ribbon the Reconnect 20.
removed. was cable the when as same the are
CDSU-II. the of cover top large the Replace 21.
frame. the into back CDSU-II the Slide 22.
earlier. removed were that screws 4 the with frame the to CDSU-II the Attach 23.
Proprietary — Technologies Lucent
instructions Company to pursuant Use