Lucent Technologies 4ESS SCS, Maintenance Manual

Page: 223 / 526

TAP-142 234-151-077AC
6 of 3 Page 1999 June 7, Issue
A TABLE Codes Error CDSU-I
Recommended Error
Code
Source Reason
Action
e.g., detected, error Internal
range. of out value
BLM 0 None.
is init soft A failed. poll Device
CDSU-I. the by initiated
and 17, phase diagnostic SCU Run
succeeds. diagnostic if SCU restore
Interject 1
BLM 2 None. failed. call system UNIX
type message IPC Bad
received. BLM 3 None.
system on EINTR Unexpected
call. BLM 4 None.
BLM 0101 card. AYC-50 failing Replace self-test. ASR failed Channel
BLM 0102 card. DTI/211 failing Replace diagnostic. board failed DTI/211
condition alarm red DTI/211
exists. are cables T1 CDSU-I the that Check
connected. properly
BLM 0103
condition alarm yellow DTI/211
exists. are cables T1 CDSU-I the that Check
the that and connected, properly
properly are SCU and CDSU-I
cable T1 given the for configured
length.
BLM 0104
condition alarm blue DTI/211
exists. BLM 0105 None.
remote the has DTI/211
ON. to set switch test loopback
set be could boards both or One
ON. to
test loopback remote the that Ensure
DTI/211 both on OFF to set is switch
information for DLP-549 See boards.
switches. DTI/211 the set to how on
BLM 0107
open device failed channel ASR
call. and 17, phase diagnostic SCU Run
It succeeds. diagnostic if SCU restore
reset manually to necessary be may
persists. problem the if CDSU-I the
bad a indicates error this Generally
jumper incorrect an card, AYC-50
a that or card, AYC-50 an on setting
which occurred has error system UNIX
CDSU-I. the of reboot a requires
Interject 0201
and 17, phase diagnostic SCU Run pump. to failed channel ASR
succeeds. diagnostic if SCU restore
bad a indicates error this Generally
card. AYC-50
Interject 0202
Proprietary — Technologies Lucent
instructions Company to pursuant Use