Lucent Technologies 4ESS SCS, Maintenance Manual

Page: 406 / 526

234-151-077AC DLP-538
1999 June 7, Issue 6 of 4 Page
cabinet. the from removed was that CDSU-I the from cover top the Remove 10.
new the to CDSU-I old the from cards AYC50 the move to steps following the Complete 11.
CDSU-I.
be to cards AYC50 the to connected cables ribbon the disconnect CDSU-I, old the At A.
removed.
in continuing and AYC50-0 with (beginning time a at One Note. and WARNING See B.
lift card, AYC50 each from screw holding the remove AYC50-11), through up order
in location same the in card AYC50 the install and card, AYC50 each remove and up
CDSU-I. new the
holding the replace and position, into seated fully is card new each that Ensure
card. AYC50 each of back the at screw
be must clip the and worn be always must strap wrist A WARNING:
any removing or inserting before on worked being unit the to grounded
CDSU-I. the from cards
Note: ribbon the A12, and A5 locations at card AYC50 the removing When
after removed be must board DTI/211 adjacent the to connected cable
DTI/211 same the to cable ribbon the Connect board. AYC50 the removing
inserted. is card AYC50 adjacent the before CDSU-I new the in card
positions same the in AYC50 the to cables ribbon the connect CDSU-I, new the At C.
CDSU-I. old the in from removed were they
CDSU-I. new the to cover top the Attach 12.
2 that recommended is (It position. into locks it until cabinet the into CDSU-I new the Slide 13.
function.) this perform people
was that pin the re-inserting by CDSU-I the of rear the at arm cable the Reconnect 14.
6. Step in removed
cabinet. the into way the of rest the CDSU-I the Slide 15.
3. Step in removed were that cable) LAN the of exception the (with cables the Reconnect 16.
later. reconnected be will cable LAN The
Proprietary — Technologies Lucent
instructions Company to pursuant Use