————————————————
Accessories from
—
The Original
——
Rev. 00 09/10/2012
Page 4 of 4
Left wiring harness (5):
Loose cables to the ignition lock and the left switch unit from the frame
mounted cable tie and bundle it with the attached small cable tie. Fix the cable to the ignition lock
with great cable tie on the ignition lock’s left spacer.
Adjust handlebar, if necessary and then tighten the clamping bolts finally. Now adjust the controls
and fix them finally. To fix the grips with the original bolts you need to drill a Ø4mm through-hole
on each side.
Make sure that no cable, hose or harness is bended and stays tension-free over the whole
steering angle.
The conversion kit is now completely mounted. Always check local laws and your manufacturer’s
warranty conditions for using aftermarket parts on your bike!
Ride safe and have fun!
5
cable tie