LSI-Robway RCI-1502 HRT, Instruction Manual

Page: 34 / 109

RCI-1502 HRT Tele Boom Manual
5.3. Calibrating Main Boom Angle
5.3.1. Calibrating Low Boom Angle
•
Safely luff the boom down to a low angle, e.g. 30°,
•
Enter calibration mode, if not already activated, and select the
correct function code (F-09) for calibrating low boom angle,
•
Accurately measure the actual boom angle using an angle finder,
•
Use the UP/DOWN keys to ramp the display to the required v alue
then press ENTER to accept this value.
5.3.2. Calibrating High Boom Angle
•
Safely luff the boom up to a high angle, e.g. 65°,
•
Enter calibration mode, if not already activated, and select the
correct function code (F-10) for calibrating high boom angle,
•
Accurately measure the actual boom angle using an angle finder,
•
Use the UP/DOWN keys to ramp the display to the required v alue
then press ENTER to accept this value.
Verify that the boom angle is accurately measured by using function code (F-08)
VIEW BOOM ANGLE. Luff the boom and stop on different boom angle points.
Check boom angle with the Angle Finder and verify accuracy against the
displayed angle.