A2C-SG2-M12
WWW.LILLIESYSTEMS.COM
15 of 44
Figure 7 Graphing data
5.1
Trouble shooting connection
If the message “No Sensor found” appears try the following.
1.
Make sure the U2C baud rate is correct. Press the Show more U2C Settings on the left pane to open up the settings for
the U2C.
2.
Disable periodic messages.
a.
Go to the Periodic Messages tab and disable all tasks.
b.
Press the Set Sensor Parameters – this will disable standard periodic messages
c.
Click the radio button “Standard send Normal value only”
d.
Unselect the check boxes “Enable channel 1” and “Enable channel 2”
e.
Click “Update A2C-SG”
3.
Press the Get Sensor Parameters again to get the parameters.