Chapter
6
Operation
Adult configuration
LM 2000 - 06.05.2021 - 09382-03
37
The adjacent button allows the operator to change
the humidity at the outlet of the water chamber.
The following parameters can be adjusted:
Chamber: °C
Patient: °C
35
39
36
39
37
39
Use the adjacent button to select the following
default temperature values:
▪
at the outlet of the water chamber: 31°C
▪
near the patient: 34°C.
The weaning mode button allows the operator to set
the weaning mode.
Select this mode only for weaning the patient off the
tracheal tube.
In this mode, the target values are not displayed and
the humidity output could be lower than specified in
the technical data.
(→
Press the button you want to select for about half a
second.
Then confirm by pressing the [OK] button for about
half a second.
Press the [Cancel] button to return to the operating
screen without saving the settings.
With the hand button, the operator can manually set
the control temperature values at the outlet of the
chamber and near the patient.
The temperature control screen allows you to change
the control temperature at the outlet of the water
chamber (left) and on the sensor near the patient
(right).
Adjust the temperatures by increasing the set value
with the [+] button and decreasing it with the [-]
button. The control temperature at the outlet of the
water chamber can be set between 29 and 37°C,
while the control temperature near the patient can be
set between 30 and 40°C.
