12
New weaving pattern in the edit mode
Existing weaving pattern in edit mode
New pattern – Select number of shafts
If you do not use all shafts, you can change the
number of shafts that are displayed. This is only to
make the image uncluttered, when weaving it makes
no difference what number is selected.
1.
Select
open settings
2.
Select the number of shafts (8, 16, 24 or 32)
3.
Select
close settings
to activate the Edit
screen
1.
open settings
2.
3.
close settings
Edit Weave Rule
By clicking in the boxes, you can turn the boxes corresponding to a lifted shaft on
or off. This is a pattern editing rule.
The shaft numbers are displayed at the top of the screen.
A black box marks a shaft to be lifted. In this example, pick 10 is displayed, shafts
that will be lifted are: 3,5,7,8,11,15,19,23,27,31
Navigation
There are always only 20 lines of pattern on the screen.
You can navigate through the pattern in different ways:
•
Select button
Up
or
Down
•
Select the box with the active line number. An input
screen appears. Type the line number you want, then
select . You may need to put your cursor behind
the last digit of the line number and select the “Bksp”
button.
Note that the navigation in edit mode does not affect the
active pick in the weaving mode. In weaving mode, you
can navigate the same way to move to a specific pick.
