Troubleshooting
Problem
Possible Solution
Light will not turn on
Verify 6-38 VDC electrical potential is
supplied to the positive (RED) wire of
pigtail connector and capable of
handing the required amperage load
of unit.
Verify negative wire is properly
grounded.
Verify all fuses in the system are in
good working order.
If relay circuit is used, verify relay is
working properly.
Check all wires for scrapes, cuts, and
other abnormalities that could cause
the system to short.
Light will not turn off
Remove electrical power from unit.
Low level of light emitted from unit
Clean polycarbonate lens in
accordance with the maintenance
section of this manual.
Emitted light not pointed in desired
direction
Change alignment of light in
accordance with the maintenance
section of this manual.
Product Maintenance Continued
4.3 Mechanical Maintenance Continued
axial adjustment and re-torque the stainless steel end cap nuts to 7ft-lbs
(84 in-lbs).
•
It is good practice to routinely verify mounting hardware is secure and
free of corrosion.
5. Troubleshooting
If any other problems or questions are encountered please contact
LOTTworx Technical Support at [email protected]
11
Product Maintenance Continued
Product Maintenance Continued
•
The polycarbonate lens on the optical side of the product has a scratch
resistant hard coat applied to the external surface; however, care must be
taken while removing wet/dried mud, dirt, dust, or other debris from the
optical side of the light to not scratch the polycarbonate surface.
NEVER USE ABRASIVES, GRITY CLEANERS, OR HARD
CLEANING IMPLEMENTS (BRUSHES, SQUEEGEES,
SCRAPERS) TO CLEAN THE POLYCARBONATE SURFACE.
AVOID THE USE OF PRESSURE WASHERS ON OR NEAR
THE SEALING SEAMS OF THIS PRODUCT
.
4.1 General cleaning of polycarbonate surface and housing
•
Thoroughly pre-rinse with warm water to loosen and wash away large
solid deposits.
•
Use a moist non-abrasive sponge or microfiber cloth to gently wash with
a diluted solution of mild soap or detergent.
•
Rinse thoroughly with clean warm water
•
Dry with a soft clean cloth to prevent water spots.
4.2 Electrical Maintenance
•
Periodically check all external electrical wires and connections for
abrasions, cuts, exposures, indications of burning, or any other
abnormalities.
•
If any abnormalities are found with the external electrical system to this
product, do not attempt to operate the unit before the abnormality is
corrected. If any portion of the wiring of the is found to be exposed,
immediately replace or repair the exposed section as required.
4.3 Mechanical Maintenance
•
It may periodically be desired to change the alignment of the light
emission. To make an axial adjustment, turn the mounting nuts secured
to the end cap stud in a counter clockwise direction to loosen. Make
10
Copyright 2015 LOTTworx
Copyright 2015 LOTTworx
