4
Mounting Continued
•
If drilling is necessary, mark where mounting holes are required.
•
Remove light and brackets from mounting surface and place light
assembly in a safe location.
•
Use a
9/32”
drill bit to drill mounting hole through mounting surface.
•
Maneuver light and mounting brackets into mounting position and
install the bottom mounting bolts, washers, and nuts.
•
Torque the bottom mounting bolt nuts to 7ft-lbs (84 in-lbs).
•
Align fixture to desired axial position and torque the stainless steel end
cap stud nuts to a maximum of 7ft-lbs (84 in-lbs).
CAUTION
•
If adjustments to illumination direction are required after electrical
installation is complete, loosen fasteners just enough to make
adjustment and re-torque applicable fasteners to 7ft-lbs (84 in-lbs).
•
NEVER
install or tighten mounting fasteners in a manner that
create a torsion, compression, or tensile force on the housing
end cap. Permanent damage is possible.
Figure 1.4: Example of
assembled mounting
brackets.(Inward Position)
Figure 1.5: Example of assembled
mounting brackets.(Outward
Position)
•
NEVER
attempt to remove the Philips screws from the housing
ends. There is delicate circuitry below these end caps that can
be damaged as a result.
Mounting Continued
5
Alternative Mounting Method Example:
•
An acceptable alternative mounting method is to utilize the factory
mounting brackets (in either the inward or outward facing position) and
secure them to a mounting surface by the use of common hose clamps;
shown below in Figures 1.6 and 1.7.
•
This method is particularly useful when securing mounting brackets to
round tubing without the use of welded brackets or drilled holes.
•
If this method of mounting is chosen, it is strongly recommended to
utilize a relatively strong hose clamp, such as a “T-Band Clamp”.
Figure 1.6: Example of
assembled mounting bracket
and use of hose clamp.(Inward
Position)
2. Electrical Installation
•
Verify electrical voltage has been removed from all wires involved in the
installation of this product prior to installation.
•
Remove negative terminal from all batteries of vehicle during installation of
this product.
Figure 1.7: Example of assembled
mounting bracket and use of hose
clamp.(Outward Position)
Copyright 2015 LOTTworx
Copyright 2015 LOTTworx
