Lorex TR 1285, Installation And Operation Manual

Page: 24 / 34

SET DAY START END SPD
OFF MON 05:52 06:52 6H
OFF DLY 07:00 08:30 6H
OFF M-F 05:00 08:25 30H
_
_
(MOVE) (SELECT) (CLEAR)
SET: Program is processed or not
DAY: Day of the week
START: Recording start time
END: Recording end time
SPD: Recording mode display
If the recording times of two programs overlap, the preceding program
is given priority, which means some of B program will be lost.
In 6H, 18H and 30H modes, sound is also recorded.
DAY mode covers Mon., Tue., Wed., Tur., Fri., Sat. or Sun.
M-F (Mon. To Fri.), S-S (Sat.& Sun.) And DLY (Daily).
DLY (in “Day of the week”)
sets the same time recording everyday.
A 24-hour DISPLAY IS USED. 00:00 indicates midnight, 12:00 is noon
and 15:00 is 3:00 p.m.
*
*
*
*
*
12:00 14:00 15:00
17:00
A
B
portion not recorded for B
Priority to the preceding program
1. Press the MENU button to display the Main Menu on the monitor.
2. Press the MOVE button repeatedly until aligns with the TIME REC SETUP position.
3. Press the SELECT button.
4. When TIMER PROGRAM CHART appears on the monitor, press the SELECT button again.
ON (or OFF) under SET will blink.
To disregard the timer program, select OFF.
5. Program timer data by pressing the UP (or DOWN) button.
To move to the next position, press the SELECT button.
6. When done, press the MENU button to exit the TIMER PROGRAM screen. Then press the POWER/TIMER button to activate the
TIMER PROGRAM. The power will be off and will be displayed.
If an error is encountered when the TIMER ON/OFF button is pressed, refer to the following table.
Symptom
does
not display
Check points
· Check if a tape is inserted. “NO TAPE” on screen.
“NO SAFETY TAB”
on screen.
“NO VIDEO SIGNAL”
· Check if the tape has a safety tap.
· Verify the camera cable is correctly
connected to VIDEO IN.
Action
· Insert a recordable tape that has safety tab.
· Replace with a tape with one that has a
safety tab.
·
·
Ensure correct connection.
Check for problems with the cable.
CAUTION:
* Because the TIMER button is shared with the POWER button, pressing POWER OFF will activate timer recording if it has
been set to ON; therefore, check setting carefully to prevent any unwanted recording.
19
TIMER RECORD
HOW TO AVOID MISTAKES WHEN USING THE TIMER +
RECORDING (CONTINUED)