TABLE OF CONTENTS
E 6
LOREME
12, rue des Potiers d'Etain - 57071 Metz
03.87.76.32.51 - Email: [email protected] - [email protected]
4) Relay #2
Display message:
RELAY #2 (Y/N)?
The top button allows access to configuration of relay 2, the bottom button allows to move to the relay 3 rubric.
5) Configurable alarms parameters for the relays
5.1) Under voltage alarm
Display message:
UNDERVOLTAGE CONFIG. (Y/N)?
The top button allows access to configuration, the bottom button allows to move to the next rubric.
Displayed message:
THRESHOLD
Threshold setting from 0 to -99%, ‘No’ to disable the under voltage detection.
The minimum measured voltage is 10 V (high voltage version) or 2.5V (low voltage version). Beneath this value, the
measured voltage is zero. The voltages are given between phase and neutral.
Note:
If the threshold is set to -99 %, they will be no undervoltage detection.
Displayed message:
ACTIVATION
DELAY
Delay setting from 0 to 600 s by 0,2 s steps between 0 and 100 s and 1 s up to 600 s.
Displayed message:
DEACTIVATION
DELAY
Delay setting from 0 to 600 s by 0,2 s steps between 0 and 100 s and 1 s up to 600 s.
5.2) Overvoltage alarm
Display message:
OVERVOLTAGE CONFIG. (Y/N)?
The top button allows access to configuration, the bottom button allows to move to the next rubric.
Displayed message:
THRESHOLD
Threshold setting from 0 to 99%, ‘No’ to disable the overvoltage detection.
Note:
If the threshold is set to 99 %, they will be no overvoltage detection.
Displayed message:
ACTIVATION
DELAY
Delay setting from 0 to 600 s by 0,2 s steps between 0 and 100 s and 1 s up to 600 s.
Displayed message:
DEACTIVATION
DELAY
Delay setting from 0 to 600 s by 0,2 s steps between 0 and 100 s and 1 s up to 600 s.
5.3) Phase asymmetry alarm
Display message:
ASYMMETRY CONFIG. (Y/N)?
The top button allows access to configuration, the bottom button allows to move to the next rubric.
Displayed message:
THRESHOLD
Threshold setting from 0 to 99%, ‘No’ to disable the asymmetry detection.
Note:
If the threshold is set to 99 %, they will be no asymmetry detection.
Displayed message:
ACTIVATION
DELAY
Delay setting from 0 to 600 s by 0,2 s steps between 0 and 100 s and 1 s up to 600 s.
Displayed message:
DEACTIVATION
DELAY
Delay setting from 0 to 600 s by 0,2 s steps between 0 and 100 s and 1 s up to 600 s.
5.4) Under frequency alarm
Display message:
UNDERFREQUENCY CONFIG. (Y/N)?
The top button allows access to configuration, the bottom button allows to move to the next rubric.
Displayed message:
THRESHOLD
Threshold setting from 70 Hz to 5 Hz, ‘No’ to disable the under frequency detection.
Displayed message:
ACTIVATION
DELAY
Delay setting from 0 to 600 s by 0,2 s steps between 0 and 100 s and 1 s up to 600 s.
