LLR03187
Installation Instructions
10
Lift Arm Tension Adjustment
1.
Tension may be adjusted with tension adjustment screw
inside cable management cover and 1/8” hex key (L). Turn
clockwise to reduce tension or counter-clockwise to
increase tension. (See Figure 15)
Figure 15
Display Removal
WARNING:
Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! (See
Figure 16)
1.
Make sure display is in the upright position.
2.
Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 16)
Figure 16
Display Removal Security Screw
NOTE:
In order to prevent display from being easily removed
from mount using the quick release lever, install
M4x4mm security screw (F) into lower hole on back of
faceplate. (See Figure 17)
Figure 17
Pivot Adjustment Range
1.
Adjust arm angles as desired within a 90 degree range from
the pivot point of the arm and a perpendicular centerline of
mount. (See Figure 18)
WARNING:
Swinging the arm beyond this range may result
in the mount slipping off the desk causing serious injury!
Figure 18
Reduce tension
Increase tension
(lighter display)
(heavier display)
Do NOT over-tension
adjustment tension
screw.
NOTE:
Lift arm
must be at highest
height to access the
lift arm tension
adjustment screw
through the access hole.
quick release tab
2
(F)
perpendicular centerline
90 degrees range
of motion per arm
pivot point of the arm
(top view)
