Installation Instructions
LLR03187
7
Using Grommet Hardware
1.
Remove desk clamp from mount by loosening button head
cap screw until clamp is completely disengaged from the
bolt. (See Figure 5)
2.
Maneuver clamp so that it is totally removed from desk
mount. (See Figure 5)
NOTE:
Set removed washers aside for re-use.
Figure 5
3.
Locate a flat surface (thickness of 3/4” minimum to 3 1/2”
maximum) on which to mount the column plate.
4.
If mounting hole does not already exist on desk, drill 3/8”
mounting hole in desk at desired mounting location.
IMPORTANT ! :
Mounting hole must be between 3/8”
and 2 1/2” in diameter!
5.
Place mount on desk over grommet hole. (See Figure 6)
6.
Use 5/16-18 x 6” button head cap screw (J), removed
washers, clamp bracket (G) and 5/16-18” square nut (H) to
secure mount to desk. (See Figure 6)
Figure 6
Display Installation
1.
Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 7)
Figure 7
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the LLR03187 Monitor Arm and
the desk up to (and including) the display does not exceed
the weight limits listed in the table below. Use with products
heavier than the maximum weight indicated may result in
collapse of the mount and its accessories causing possible
injury.
2
1
removed
washers
(G)
(H)
(J)
6
removed washers
MODEL
Max Weight
Allowed for EACH
Display
Max Weight
Capacity of Mount
LLR03187
25 lbs
(11.3 kg)
50 lbs
(22.7 kg)
quick release lever
1
1
