Start-up
- 17 -
11.18
909.1550.1-08
machine) to maximum (set welding current on the
machine).
If the setting is 100A, for example, the remote
control can call up 10A - 100A.
61
The polarity switch
is used to change the polarity (only machines with
polarity reverser)
The machine is protected against multiple chang-
es at short intervals by a 2-second delay.
62
The standby switch
is used to activate / deactivate standby mode
(idle state)
The switching position of the remote con-
trol has priority over the settings on the
welding machine.
Remote control without polarity and standby
switch
When using the Lorch remote control without polarity
and standby switch, the Remote control secondary
parameter must be set to OFF (Code "FrA" = OFF).
Â
Plug the remote control into the remote control con-
necting socket 7.
Â
Press button 55 to call up the secondary parameters.
Â
Select the Remote control secondary parameter
(Code "FrA") by rotating the control knob 56.
Â
Confirm the secondary parameter by pressing the
control knob 56.
Â
Set the value "OFF" by rotating the control knob 56.
Â
Confirm the setting by pressing the control knob 56.
Â
Exit the secondary parameters by pressing the Menu
button 55.
If the Remote control secondary parameter
is set to On (Code "FrA" = On), the welding
machine behaves as follows:
●
Standby mode is activated when the welding cur-
rent rotary knob of the remote control is set to
minimum.
●
The polarity cannot be changed on the control
panel.
Contact remote control KR 10
The contact remote controller KR 10 is not
used with the devices X 350 VRD.
A contact remote control for setting the welding current
is available for the X series (only suitable for electrode
welding).
Â
Clamp the contact remote control in the electrode
holder.
Â
Position the contact remote control with the free end
on the workpiece or the welding bench (potential of
the ground clamp).
Â
Set the desired welding current with buttons 65 and
66.
Â
Transfer the set welding current to the machine using
button 67.
65
66
67
Abb. 11: Contact remote control KR 10
i
i
i
