Installation (for qualified installers only)
9
© Travis Industries
4/23/2021 - 1449
Radiant Large GSB2
Factory-Built (Metal) Wood-Burning Fireplace Requirements
The damper ("A") and grate (with log set) ("B") must be removed (see the illustration below).
The smoke shelf ("C"), internal baffles ("D"), screen ("E"), masonry lining or refractory ("G" & "I"), and
metal or glass doors ("F") may be removed (if applicable).
The insulation ("H"), and any structured rigid frame
members must not be removed or altered (side and
top of door frame, side and top of the face of the
fireplace, metal sides, etc.).
The metal floor (“J”) of the firebox may be removed
in certain cases*.
The fireplace must be permanently marked to
indicate that it has been altered and is no longer
suitable for burning solid fuel (wood), unless the
removed parts are re-installed. Cutting of any
sheet metal parts is prohibited. Surround panels
should not seal ventilation openings on the
fireplace.
*CAUTION:
Firebox floor removal is not covered under the appliance safety standard (ANSI
Z21.88 CSA 2.33
)
used in the safety certification of this appliance, however, this method has been tested by Travis Industries and
it has been determined to be safe following the instructions below. Before installing the appliance using this
method, contact the Authority Having Jurisdiction to determine if this installation is acceptable in your area. The
sheet metal base ( or metal wrap) of the fireplace must be left in place.
If the factory-built fireplace has no gas access hole(s) provided, an access hole of 1-1/2” (38mm) or less
may be drilled through the lower sides or bottom of the firebox in a proper workmanship like manner. This
access hole must be plugged with non-combustible insulation after the gas supply line has been installed.
Hearth Requirements
The heater and face must not contact combustible surfaces. A non-combustible hearth extension is
not required. However, if the heater is installed next to the floor, we recommend a hearth to protect
the flooring surface from discoloration or other negative impact from the heater.
