
Installation
(for qualified installers only)
55
© Travis Industries
11/9/20 - 1478
PB 72 GSB2/GSR2 Aust.
5 Follow the green and white wires to where they attach to the control module. Disconnect the
green, plastic connector from the control module by lifting straight up (location is marked X4
on the module). Remove the connector and wires from the unit and discard. Install the
switch blank into the empty mounting hole of the switch that was removed.
6 Install the system jumper into the same location on the board that you removed the green
connector in the previous step.
7 Locate the battery holder on the appliance. Disconnect the wires at the plastic Molex
connector that connect the battery holder to the appliance wiring harness. Discard the
battery holder.
8 Run the end of the included wire harness with (4) wires to the control module. Insert the
connector into the “X8 User Interface” location on the module.
X4
Remove and discard
harness and connector
Replace with
included jumper
X8
Disconnect