Chapter 5 Terminal Operation
5-15
The upload procedure is similar to the download procedure:
A. Connect the Loop-V 4200 to the TFTP server through the Ethernet port located in the back of the device.
NOTE:
Use straight Ethernet cable if an Ethernet Hub is used. Use a cross-over Ethernet cable for a direct
connection from TFTP server to the Loop-V 4200.
B. Run the TFTP program. A screen will be shown with the server IP address displayed.
I.
Hook-up the COM PORT 1 of the VT100 (PC running VT100 emulation) to the Loop-V 4200 through the
front console port.
J. Run a VT100 terminal or TELNET program after connecting to the Loop-V 4200. A TELNET terminal will
show screens similar to the VT100.
K. From the main menu, press "T", then select UPLOAD of controller firmware.
L. ENTER the proper TFTP Server IP address and firmware file name (file to be upload). Note: If the TFTP
program and the firmware reside on separate volumes (hard disks), enter the complete file address
including volume prefix, i.e. C:/file/name for hard disk, A:/file/name for floppy.
M. Press ESC and confirm with Y.