Lonking CDM307, Operation Manual

Page: 55 / 81

CHAPTER III MACHINE OPERATION
49
3.6.1.3 Please adjust, fix and lock the seat, fasten seat belts before starting the machine.
3.6.1.4 Put down the safety lever. only when lowering the safety lever, the machine could start.
3.6.1.5 warm up the machine at an idle speed after the machine starts. Until water outlet
temperature of the diesel reaches 55
℃
and the engine oil temperature reaches 45
℃
, do not operate the
machine with full load.
3.6.2 Park the machine on level ground and place a pad in front and rear tires to
prevent the machine sliding. If the machine park on the lamp for a while, put a more
stable wedge under the wheel in order to avoid the machine sliding.
3.6.3 parking the machine
3.6.3.1 If the machine has been operated with full load, let the engine run at an idle speed for 5
minutes with empty load in order to cool down every part of the engine.
3.6.3.2 Turn the key of the electric lock to the "system power" position (as shown in figure 11),
the engine shuts down normally.
3.6.3.3 Please lower the lift arm to the ground before leaving the machine.
3.6.3.4 Remove the key, lift the safety bar to lock loading control lever, release the seat belt, use
the handrails and pedals to leave the cab.
3.7 OPERATION CONTROL
3.7.1 OPERATION PREPARETION
3.7.1.1 The speed of shoveling materials loader should be reduced to less than 4km / h.

3.7.1.2 Cleaning the working sites, filling pits, cuspidal stone and other damage to the tire and
obstacles impeding operation.

3.7.2 OPEARTING WAYS
3.7.2.1 general operation
Warning:
Any part of your body can not leave the cab during the operation. Before you leave the
cab, remember to lower the bucket to the ground, and turn off the engine. If you do not comply with these
steps, may result in casualties.
Warning:
The bucket should be placed as low as possible during the loading operation, so that
the driver vision is more wide, and better to keep the stability of the machine. Operation on the rough
ground and the bucket is full loaded should slow down the machine. If the speed is too high, may lose
control or even overturn.
Warning : If the bucket is uplift and the driver is not in the cab may cause casualties. so be sure to
lower the bucket to the ground before leaving the cab , or locking arm lock pins and turn off the engine.
Warning:
Do not turning with arm lifting high, or may cause overturn.
1
、
Lower the lift arm at the lowest and run the engine at the maximum speed, then shovel the material
at the speed of 2.5km/h.(as shown in the figure 21)