CHAPTER III
MACHINE OPERATION
47
3.5.2
CHASSIS SENCTION
3.5.2.1
Check the amount of hydraulic oil.
3.5.2.2
Check the hydraulic system piping and accessories of seal.
3.5.2.3
Check the flexibility of the joystick and whether on Neutral position.
3.5.2.4
Check the tire pressure is normal.
3.5.3
STARTING THE ENGINE
3.5.3.1
Check the meter indication is normal.
3.5.3.2
Check the condition of the lighting equipment,indicator light, horn, wiper, oil scale
3.5.3.3
Manipulate the device and check the condition.
3.5.3.4
Low-speed operation of the engine and check the condition.
3.5.3.5
Starting in the cold temperature
The operator should preheat the engine electrically in the cold temperature.
(1)
Turn the electric key switch to the "system power". Press down the preheating control switch
in order to supply the power to the engine preheating plug (the preheating time is 5 seconds every time,
after 5 seconds preheating light in the instrument is off).
The standard preheating time under the different temperatures is shown in the following table. After
preheating the engine, don't need this operation.
Preheating control switch
( auto reset
)
Summary of Contents for CDM307
