Lonking CDM307, Operation Manual

Page: 42 / 81

CHAPTER III MACHINE OPERATION
36
Figure 11 KEY SHIFT POSITION DIAGRAM OF ELECTRIC LOCK
3.2 OPERATION OF SKID STEER LOADER
3.2.1 PRECAUTION WHEN OPERATING
3.2.1.1 Diesel of skid steer loader should be pure and be deposited for at least 72 hours , diesel
No. should meet the stated quality requirements.
3.2.1.2 A regular maintenance and lubrication foe skid steer loader should be performed following
the regulation.

3.2.1.3 After starting the engine, run the engine at an idle speed. start traveling until the water
temperature reaches 55
℃
.
3.2.1.4 The temperature is generally below 10
℃
, electrically warm up the engine before the
engine start-up. Turn on the start gear for 10 seconds, if the engine can't be started , restart the engine
after 30 seconds.
3.2.1.5 Full-load operation when the diesel engine water temperature higher than 55
℃
, the oil
temperature is higher than 45
℃
. The engine operation water temperature and oil temperature should
not exceed 95
℃
. The overloaded operation water temperature and oil temperature exceeds the
allowable value should stop the engine for cooling.

3.2.1.6 Does not allow the bucket to the highest position carrying materials, delivery of materials
should keep the hinge of the boom away from ground about 400 mm, in order to ensure stable travel.
3.2.1.7 The diesel engine power is decreased with the increase of altitude, ambient temperature
and relative temperature. so the user must use the loader adapt to the local environment, according to