ForceCut™ Series Plasma Cutters
www.longevity-inc.com
8
Making Machine Connections
Use the pictures shown below as a guide when making the connections described in
the following paragraphs.
Connecting the Power Cord Plug
Instructions for selecting and connecting up the machine’s power cord plug are
described in the user manual,
Instruction Manual for Electrical Plug Selection and
Wiring,
which is available on the www.longevity-inc.com website. Please note that
the green with yellow inside is the ground wire. If you are wiring to 220v, the other
two wires are both hot wires and each wire will need to be connected to each of the
hot terminals.
Connecting Cables to the Machine
Connect the cable to the machine as follows:
1.
Locate the ground clamp and end connection.
2.
Place the connector into the machine’s ground connection, and turn it
clockwise for approximately one-third turn until it locks into position.