Appendix - Relocating
Page 102 of 106
•
Appendices
•
Relocating your Lomond printer
Once your printer is set up and working to your satisfaction, you should not move it but leave
it connected and switched on for best performance.
If you need to move it to another location in the house or in your office, read the section
labelled
Local relocation
below.
If you need to relocate it to a different building or office, read the section titled
Remote
relocation
on page 103.
Local relocation
Transporting the printer from one room to another in the house or to another office at work is
considered a local relocation. Local relocation does not normally require that the printer be re-
packaged before transportation.
To minimise the chance of ink leakage due to incorrect handling, your printer must be placed
in ‘transport mode’ before relocation. This requires you to switch off the printer as set out
below:
1.
To place your printer in ‘transport mode’:
1.
When the printer is idle and the
Ready
message is displayed on the LCD screen,
press the Menu button.
2.
Use the Up or Down button to select
Transport mode
, and then press the
OK/Resume button.
3.
Press the OK/Resume button again to confirm. The power lamp begins to blink and
the
Transport mode Setting...
message appears on the LCD screen.
4.
Wait until the power lamp stop blinking and the printer is powered off. Your printer is
now in ‘transport mode’.
2.
Disconnect the power cable from the wall socket.
DO NOT switch off the power at the power outlet or remove the power cable before the power
lamp has ceased blinking. Failure to do so may damage your printer.
3.
Disconnect the USB or Ethernet cable from your printer.
4.
Lift the printer keeping it as level as possible whilst doing so. It is recommended that two
people are used to lift and move the printer, as this makes it easier to keep the printer
level.
The printer should remain level at all times during relocation or storage. Failure to do so may
cause the printer to leak ink.
5.
Take care to avoid bumping the printer during the move.
6.
When re-installing the printer in the new location, select the location as set out in the
Locating your printer
section on page 18.