A
C1
G1
H1
J1
J
8 pcs.
J2
A
J1
C
J1
G
page 11
13. Scope of supply
13. Scope of supply
A
Base (bottom)
C1
Sidewall preassembled
G1
Front panel preassembled
H1
Base cover front
J
Mounting accessories enamel covering
J1
Sheet metal screw 4,2 x 10 mm
14. Installing the panels
14. Installing the panels
Base (bottom)
Place the base (
A
) in front of the appliance and push it from the front under
the pellets module. (Fig. 14).
The two supplied screws (J2) are to be attached to the appropriate drill-holes,
however, do not tighten them yet!
Side wall
Hook the sidewall (
C1
/
C2
) into the appropriate openings at the base and fas-
ten it at the top with both supplied screws (
J1
). Use adjusting screws to level
out unevenness of the floor and distances in height (figure 15).
Connections main plate
Provide the connections at the main plate (see terminal connection diagram
on page 25).
Front panel
Connect the flat ribbon cable of the control panel at the main plate. Insert
the front wall (
G
) as illustrated and fasten it at the top with two screws (
J1
),
(figure. 16).
Adjust the completely assembled built-in cupboard at the stove front. Tighten
the screws which fasten the base! (figure 14)!
If necessary take out the adjustable foot of the stove a little to facilitate this
procedure!
If necessary take out the adjustable foot of the stove a little to facilitate this
procedure!
fig. 14
fig. 15
fig. 16
fig. 17
adjusting screw