Logosol B1001, User Manual

Page: 18 / 64

18
1
TOEBOARD
1 2
3
0
3 5
01-00767
2
TOEBOARD
POSITION
In order for all functions to fit on the rails, the position
is important. We start from the joints on the rail pipes
and then count the hole pattern from the relevant
joints to find the correct position.
The assembly assumes that the saw rails have an
extension. If a second extension is fitted, it shall be
mounted on the far end of the rails.
The parts from packages are needed to start the
assembly.
01-00767
We recommend laying out all
fasteners on a tray or similar to make the task easier.
The log beds are positioned on pipes number 3
and 5 viewed in the sawing direction. The beds
are then placed on hole pattern 3 counted from
the joint of the pipe in the sawing direction.
Count the hole patterns from the pipe joint,
the log beds should be placed on the third hole
pattern from the respective pipe joint
Position 01-00767
Hole pattern
Pipe
joint
Sawing direction
To be able to mount new functions in the rails,
it is important to release existing log beds
in order to facilitate installation of the new
functions.
The symbol describes the
sawing direction and reappears
during assembly.
When this symbol appears
during assembly, parts
must be lubricated before
installation. Lubricate
affected parts with universal
grease.
Rail
pipe
ASSEMBLY