34
4
5
0.5 mm
1 mm
2 mm
X mm
X mm
Lock
Adjusting
nut
To ensure a good sawing result, it is important that the band
blade is parallel with the cross bunks. Measure the vertical
distance between the blade and the cross bunk. Note down the
measurements.
When carrying out this adjustment, the blade guide rollers have
to be removed.
Adjust the band blade by turning the adjusting
bolts on the sawhead until the measurements
are the same at both measuring points.
ADJUST THE PARALLELITY BETWEEN THE
BAND BLADE AND THE CROSS BUNKS
ORDER OF ADJUSTMENTS
The adjustable blade guide with guard
has to be adjusted to ensure straight cuts
in all positions. Install the blade guide
rollers. Then, bring the blade guide with
guard to its innermost position. Place a
spirit level on the blade guide and adjust
by turning the eccentric handle until the
blade guide with guard is horizontally
level. When it is level, use spacers on the
fixed blade guide roller until both blade
guide rollers have the same distance to
the cross bunk.
ADJUST THE ADJUSTABLE BLADE GUIDE HORIZONTALLY
As standard, the sawmill comes with
2 mm spacers installed.
Measurement
point 1
Measurement
point 2
