25
B1001
2
3
4
1
BRIGGS 23 HP
WARNING!
Risk of serious injury.
Before adjusting the tension of the throttle
wire on the engine: Turn the ignition key to the
OFF position and close the fuel valve.
Always start the machine from the operator’s
station. Always turn off the machine before
adjusting the tension of the throttle wire on
the engine side.
WARNING!
Risk of burn injuries. The engine
and its muffler get very hot during operation
and remain hot a while after operation.
Allow the engine and the muffler to cool
before you perform any adjustments or
maintenance on the machine.
• Start by setting the throttle cable adjustment
at the throttle handle so that you have equal
adjustment allowance in both directions
(1)
.
• Attach the other end of the cable sheath to the
engine clamp
(2)
.
• Screw the cable to the nipple
(3)
. Make sure
that the throttle is in the neutral/unaffected
position when doing this.
• Make sure that you have 1-3 mm of play in the
throttle handle and that the cable moves freely.
If necessary, adjust the tension of the cable at
the throttle handle
(1)
.
• Start the engine and check that it is idling and
that the saw blade does not move while the
throttle handle is in idle position. If necessary,
adjust the tension of the cable at the throttle
handle
(1)
.
• Secure the adjustment using the counter nuts.
(4)
.
THROTTLE ADJUSTMENT