LOGO SILVER ALLTRACK M3 Series, Owner'S Manual

Page: 20 / 48

20
VIII. SET-UP, ADJUSTMENT & USE
ADJUSTMENT AND USE
NOTES:
1. WORK SURFACE FOR SET-UP
Use a flat surface, such as a table, to assemble, adjust and
check the power wheelchair. This makes the steps easier and
helps ensure a correct set-up.
2. FASTENERS
• Many of the screws and bolts on this power wheelchair
are special high-strength fasteners and may have
special coatings.
• Many nuts are of the nylon insert lock nut type.
They have a plastic insert to help prevent loosening.
• Only use screws, bolts and nuts provided by LOGO
SILVER .
!
WARNING
1. Use of improper fasteners may cause the power wheelchair
to malfunction.
2. Over- or under-tightened fasteners may fail or cause
damage to power wheelchair parts.
3. If bolts or screws become loose, tighten them as soon as you
can. Loose bolts or screws can cause damage to other parts
causing them to fail.
4. WASHERS AND SPACERS
• Note the position of washers and spacers
before disassembly.
• To avoid damage to the frame, replace all washers and
spacers when you reassemble parts.
TOOLS YOU WILL NEED
BASIC TOOL KIT
To set-up, adjust and maintain your power wheelchair you may
need the following tools:
• Phillips and and Robertson #3 (square) screwdrivers
• Metric wrenches from 10 mm to 13 mm
• Metric Allen wrenches from 3 mm to 6 mm
• Imperial wrenches from ¼” to
9
/
16
”
• Imperial Allen wrenches from
5
/
64
” to ¼”
• Imperial socket from
7
/
16
” to ¾”
• Ratchet
NOTE - These tools can be found in common hardware stores.
BATTERY USE
(Fig.1-2 on next page)
CABLE AND FUSES
Your Alltrack is equipped with two safety mechanisms which uses
a breaker and MIDI style fuses.
NOTE - In the unlikely event of a short circuit or heavy overload,
all power to your wheelchair will be shut off. To reset your
wheelchair, press the breaker button. Should resetting the breaker
not solve the problem, you will need to replace the battery
harness which includes the fuses.
1. TO RESET THE BREAKER
AND ACCESS THE BATTERY HARNESS
(Fig.1-2 on next page)
a) Squeeze tabs together to open the door.
b) Drop the panel down and pull out the batteries (A).
c) Reset the breaker or replace the battery harness by
following the wiring instructions located inside the
battery access door.
d) Push the batteries back in the compartment.
e) Lock the panel back in its upright position and make
sure the tabs are secured on each side of the battery
compartment.
REPEATED SHUTDOWN:
If the power wheelchair continues to pop the breaker
or blow the fuses, please have it serviced by your
authorized supplier.