22
B1
B2
A1
A2
7.1 Tensioning the chains
When the unloaded forks can be tilted manually approx. 5 cm, the chains should be
tensioned.
This is done by:
1) Removing the cover from the tilt unit.
2) Loosening the gear motor (A1)
3) Loosening chain wheel (B1)
4) Turning the nut (B2), so that the fork chain is tensioned, until the slack is about
5 mm.
5) Tightening the chain wheel (B1)
6) Tightening the nuts for the gear motor (A2), so that the chain is tensioned, until
the slack is about 2-3 mm. Tighten the nuts (A1) again.
7) Replace the cover.
NOTE!
Check the location of the inductive switch (see 7.2) and check that the fork chain is
tighened correctly in the whole rotation area after adjusting the chains.
Axle for
gear motor
Axle for chain
wheel
7.0 Adjusting the Rotator
Summary of Contents for LOGIFLEX ELFR
Page 1: ...LOGIFLEX ELFR ELFSR ROTATOR...
Page 27: ...27...
