DEFAULT PASSWORDS
Logicube Talon Ultimate™ User’s Manual
72
1.
Login with the username “
it
” (without
the quotes) and the password “
it
”
(without the quotes).
2.
From the main prompt, type
command
then press the enter key.
3.
Type
config
then press the enter key.
4.
Type
db list
then press the enter key.
This will show a list of databases or
configurations saved. The example
below shows two databases (the
default initial.db and Lock.db). The db
that shows an asterisk (*) before the
name is the current database or
configuration being loaded each time
the Talon Ultimate is turned on.
5.
Type
db
load initial.db
then press the
Enter key to load the default database.
There should be a response showing
“Command (DbManagement)
Successful”.
6.
Type
db list
again and there should be
an asterisk (*) on initial.db.
7.
Turn the Talon Ultimate off using the
power switch located in the back of the
device, and close the Telnet/SSH
application.
8.
Wait for the Talon Ultimate to
completely turn off then turn it back on.
When the Talon Ultimate boots up, it
will load the default configuration. The
default configuration can be checked by
going to
System Settings
and looking at
the
User Profiles/Configurations
tab.
INITIAL.DB should have an asterisk next
to it (as seen below).