LogicPower LPM-1100VA-P, User Manual

Page: 5 / 16

USER MANUAL
WWW.LOGICPOWER.UA
Battery charging
AFTER SHIPMENT FROM THE FACTORY THE BATTERY NEEDS CHARGING. IF NOT USED FOR A LONG PERIOD
OF TIME, THE BATTERY WILL START SELF-DISCHARGING, WHICH MAY RESULT IN A SHORT SERVICE LIFE
OF THE BATTERY OR MAY EVEN CAUSE DAMAGE TO IT DURING WARRANTY PERIOD. CARE SHOULD ALSO
BE TAKEN TO AVOID EXCESSIVE TEMPERATURE AROUND THE UPS, WHICH COULD ALSO RESULT IN REDUCING
SERVICE LIFE OF THE BATTERY. TO ACHIEVE MAXIMUM SERVICE LIFE FROM THE BATTERY THE ABOVE
INSTRUCTIONS SHOULD BE FOLLOWED.
UPS indicators and controls
ON/OFF button
Press this button for 3 seconds to supply power to the UPS outlets or to switch off power to the UPS outlets.
The button is located on the front panel of UPS.
AC NORMAL INDICATOR
(Green continuous)
The UPS is supplying conditioned utility power to its outlets.
BACKUP INDICATOR
(Red led continuous bright)
The buzzer beeps every 8 seconds. The battery is powering the UPS outlets. The expected runtime for a typical
personal computer (PC) is about 3 to 20 minutes.
LOW BATTERY INDICATOR
(Red led continuous bright)
The buzzer beeps fast whenever the battery is near the end of its runtime.
Promptly save your data and exit all applications and shutdown the operating system.
OVERLOAD INDICATOR
The yellow led flashes, with continuous beeping. UPS protects itself at this time. Please move some load.
The UPS battery charges whenever the UPS is connected
to utility power & is switched ON.
It typically requires more than 12 hours to charge fully.
Operating runtime is reduced until the battery is fully charged.
The UPS contains the lead acid battery inside, which don't require
the servicing.
Bad conditions, frequent discharging and excessive
temperature reduce service life of the battery. It's also reduces if battery
hasn't been used. The battery should be discharged once every
3 month at normal voltage.