LogicPower LPM-1100VA-P, User Manual

Page: 6 / 16

USER MANUAL
WWW.LOGICPOWER.UA
4
SPECIFICATIONS
Capacity
Input voltage
Output voltage
Output waveform
Output frequency
Battery rating
Backup time
Noise level
Operating temperature
Humidity
Dimensions
Weight
USB Interface
Socket RJ-11 850VA
12V/8,5Ah
305x89x140mm
5.6 kg
+
+
TEST THE UPS
To test the UPS on battery back-up, switch off utility supply and observe ‘backup indicator’ lights. Also your PC should
continue to function normally.
1. Self-testing while switching on
Before turning on the UPS, the red/yellow/green led will be bright twice by turns. Then the UPS will be ready for operation.
2. Silence Function
In Battery Mode, shortly press the switch will enable or disable the buzzer. But when UPS is low battery or overloaded,
the buzzer can not be silenced.
3. Autorun
In DC mode, UPS discharges till battery run out and cut off, UPS autorun when AC recover.
4. Overload protection
When the UPS is overloaded while operating, which is not solved by the user in time, it will cut off the output automatically.
5. Low battery shut off
When the battery is about to be exhausted, UPS will shut down automatically to protect battery’s life.
6. Switching off
1) AC Normal. UPS will cut off the output and goes to AC standby mode by pressing the switch for 3 seconds.
2) Backup. Press the switch for 3 seconds, the UPS will be turned off after a long beep.
TROUBLESHOOTING
SYMPTOMS POSSIBLE CAUSES ACTIONS TO TAKE
UPS can not be turned ON UPS is not connecting to AC
and Overloaded Please connect to AC
and reduce the load
The input fuse is burnt
or breaker is off Replace the fuse or reset the breaker, remove some
load and check if the load is short-circuit or faulty
AC input voltage is too low
The UPS is failure
Please check the AC Input voltage
Please send device to service center
The red LED continuous
bright with a beep every
8 seconds
UPS suddenly turns to battery
mode in spite of utility line present
Save the data promptly and shut down
the operating system
The red LED continuous
bright with a beep every second
Back-up time less than specified Overloaded Please reduce the load
Battery is not fully charged
Recharge the battery for at least 12 hours
and retest the backup time
Charging unit fault Please send device tol service center
Backup time less then 1 minute Close the system and recharge again
LPM-U850VA-P LPM-1100VA-P LPM-U1100VA-P LPM-U1400VA-P
1100VA
145VAC~290VAC
220±10%VAC
Pure sinewave/approximated sinewave
50 /60 Hz
12V/7,5Ah x2
3-20 minutes
Less than 45 dB
0~45 ° C
10 to 90% non condensing
345x145x160 mm
8.2kg
-
-
1100VA
+
+
1400VA
+
+