User Manual
LogicSP-2-1 / LogicSP-2-2
Page 17 of 29
Note:
The threshold triggering the TV-Overheating Protection varies depending on the
specifications of the carrier manufacturer and the version of your control box.
Refer to the LogicSP-2-1 / LogicSP-2-2 datasheet for details.
4.2. Advanced Functionality
Note:
Accessibility/applicability of the functionality described in this section depends on
the type of control box you purchased and the handset you are using.
Accessibility of some of these functions via remote control depends on the remote
control you are using.
4.2.1.
Saving a Viewing Position
To store a new viewing position:
•
Press first the SETUP and then the UP button and hold them for at least 3
seconds until the LED is flashing.
•
You can now use the UP and DOWN buttons to move to the desired viewing
position. The TV-set carrier will move only as long as a key is pressed in this
mode.
•
Once you have reached the desired viewing position, press SETUP again to
save it.
The new viewing position is now stored.
4.2.2.
Accessing the Viewing Position
If a viewing position is stored:
•
Pressing the UP button for less than 2 seconds will move the carrier to the stored viewing
position.
•
Pressing the DOWN button for less than 2 seconds will move to the lower end position.
•
It will not be possible to move above the stored viewing position in normal mode.
Note:
It is not possible to store a viewing position below the heat-protection level. The
device will exit SETUP mode properly when attempting to store such a position but the
viewing position stored will be the heat-protection level (approx. 30 cm).
Note:
Neither any of the SETUP modes nor BYPASS mode, of course, will permit
movement above the absolute upper end position or below the absolute lower end
position.
4.2.3.
Saving the Rotation Level
Definition:
The
rotation level
is the position above which it is safe to rotate the carrier.
Note:
It is imperative you read this section
carefully
before programming a new rotation
level!
