User Manual
LogicSP-2-1 / LogicSP-2-2
Page 11 of 29
1. Position the control box with the mounting plate attached on the wooden LiftBox™ backplane
where you want to install it.
2. Mark the edge of the mounting plate with a pencil.
Fig. 3 – Mounting the LogicSP Control Box, Step 1
3. Detach the mounting plate.
4. Align the mounting plate with the pencil line and mark the two drill holes.
5. Pre-drill these 2 holes.
6. Fix the mounting plate with 2 screws in the pre-drilled holes.
Fig. 4 – Mounting the LogicSP Control Box, Step 6
Note:
Note the wedge-form of the mounting plate (see Fig. 4)!
(Make sure this angle points towards the wooden backplane.)
7. Slide the LogicSP control box onto the mounting plate so it is fully inserted in the control box
housing.
Fig. 5 – Mounting the LogicSP Control Box, Step 7
