Loctite VoluDrop UV 97650, Operating Manual

Page: 5 / 18

5
1 Please observe the following
1.3 For Your Safety
For safe and successful operation of the unit, read these instructions completely.
If the instructions are not observed, the manufacturer can assume no responsibility.
Be sure to retain this manual for future reference.
When working with pressurized air, wear protective glasses!
Observe general safety regulations and manufacturer’s instructions for the
handling of chemicals.
If chemical products are not properly handled, damage to health can result!
Request a safety data sheet for the LOCTITE
®
-adhesive used!
1.4 Field of Application (Intended Usage)
The VoluDrop Dispenser is suitable only for the exact drop application of
LOCTITE UV acrylics up to a viscosity of 15,000 mPas.
It is not suitable to dispense UV acrylics with anaerobic component,
cyanoacrylates, abrasive adhesives and anaerobics.
Only drop dispensing is possible.
Up to a viscosity of 5,000 mPas the dispenser is able to spit adhesives.
Spitting is possible form 3 µl up to 15 µl, non-spitting from 0.8 µl up to 3 µl.
Within a distance of 50 mm a feed motion of the workpiece is not necessary. The
dispenser should be mounted with the dispensing needle downwards.
The dispenser is used as a stationary applicator unit. It is mounted directly at the
dispensing position. The free end of the product feedline is connected to the product
reservoir.
For product reservoirs, 0.5 l and 2 l versions are available.
The control of the dispenser is provided by a control unit of the LOCTITE equipment line.