1
1
Please observe the following
1.1
Emphasized Sections
WARNING!
Refers to safety regulations and required safety measures that protect the operator or other
persons from injury or danger to life.
Caution!
Emphasizes what must be done or avoided so that the unit or other property is not damaged.
Notice:
Gives recommendations for better handling of the unit during operation or adjustment as well as
for service activities.
1.2
Items Supplied
Carefully remove the system from its shipping carton and inspect it for any signs of damage. Any
damage should be reported immediately to the carrier. Refer to the list of supplied parts below
and compare to the contents. Report any missing parts promptly to the Loctite customer service
department at 1-800-LOCTITE or 1-800-562-8483.
(1) Power Supply with attached input power line cord and output cable with connector to
irradiator.
(1) UV Lamp and Irradiator (reflector) Assembly.
(1) Pair UV Safety Glasses.
(1) Instruction manual.
1.3 For Your Safety
IMPORTANT!
Do Not operate the unit before reading this section.
1.3.1
Ultraviolet Light Safety
The Loctite
®
High Intensity Ultraviolet Source is a source of long wavelength ultraviolet light
used to cure light sensitive products. It produces intense ultraviolet (UV) light, which can cause
serious burns to the skin and eyes. The light is similar to that which causes sunburn but is
much stronger. Like a sunburn, UV burns of the eyes or skin are not felt until several hours
after the burn occurs. All personnel involved in the operation of the High Intensity Ultraviolet
Source should be familiar with the safety guidelines described in this manual. The following
guidelines should be followed at all times to ensure protection from the ultraviolet light.
1. The High Intensity Ultraviolet Source has no shielding. The user must provide shielding to
prevent exposure of operating personnel to direct or first bounce reflected light. Refer to
Section 3 of this manual for additional information.
2. UV protective glasses with side shields should be worn when working with and around the
lamp system. Glasses should meet ANSI Z87.1 certification.
☞
