8
Figure 6B
Figure 7
Figure 6A
Figure 9
Figure 8
CAUTION:
Use care when assembling to ensure that the cable lies against
the back recessed area of the inside escutcheon (Fig. 6A).
Position and bend cable, using the harness clips as shown in Fig.
6A to prevent binding when installing the escutcheon over the
mounting plate.
6. Attach cable assembly to the inside escutcheon PC board by
lining up notches on top of cable connector to slots on PCB
connector (Fig. 6B).
NOTE:
Connector should be pressed in firmly using thumbs until
completely seated.
Proper position is indicated by arrows on PCB as in Fig. 6A & 6B.
7. Install inside escutcheon on inside mounting plate. Note the
horizontal orientation of the tail - piece (Fig. 7) as you insert
the inside escutcheon (thumbturn should be vertical).
8. Install and secure using (3) M4 x 8mm pan head screws
through the inside escutcheon into the mounting plate (Fig. 8).
IMPORTANT:
Before installing the batteries, test
the mechanical operation of the lock by using both
thumbturn and the key. The movement of the bolt
should be smooth and unobstructed. If operation
is not smooth, review the previous steps to ensure
proper installation.
NOTE:
The bolt must be in a retracted (unlocked) position prior
to installing the batteries.
9. Insert four (4) AA alkaline batteries. The lock responds with
a series of beeps, and a quick flash of all keypad LEDs. When
activating the lock for the first time, the lock will adjust for proper
handing.
NOTE:
Refer to programming instructions prior to completion of
step 10.
10. Install battery cover and tighten Phillips head screw.
Master PIN Setting*
1
3
2
Register User PIN
Default settings
in
bold.
Advanced Lock Settings
Summary of Contents for Digital Deadbolt
Page 2: ......
