18
Reset Lock to Factory Default
Factory Default Settings
Cable
Reset Button
Inside Escutcheon
TO RESET THE LOCK TO FACTORY DEFAULT, SEE THE FOLLOWING:
The following procedure returns the lock to its factory defaults by
deleting all user codes
(including the Master PIN code)
and returning
all programming features to their original default settings (see below).
1. Remove the batteries and then remove the interior escutcheon to
access the reset button.
2. The reset button (see image at right) is located above the PCB cable
connector.
3. Hold down the reset button for a minimum of 3 seconds and then
reinstall the batteries; once the batteries are properly installed,
release the reset button.
All features, should now be returned to factory default. Upon reset,
Master Code Registration is the only option available and
must be
performed
prior to any other programming of the lock.
See
“Operation”
in this manual for programming instructions.
*The Master PIN code must be registered prior to any other programming of the lock
Settings
Factory Default
Master PIN Code
Registration required*
Automatic Re-lock
Disabled
Inside Indicator Light
Disabled (Off)
One Touch Locking
Enabled
Audio
Enabled (Low)
Privacy Mode
Disabled
Automatic Re-lock Time
30 Seconds
Wrong Code Entry Limit
5 Times
Shutdown Time
60 Seconds
Summary of Contents for Digital Deadbolt
Page 2: ......
