Lockwood Digital Deadbolt, User Manual

Page: 15 / 21

15
3. Pairing a Z-Wave/Zigbee Controller
Repeat step A.
The Digital Deadbolt will show the option below.
NOTE: (If the Lockwood Wireless Digital Deadbolt continues showing B, “Exit the network” the Digital
Deadbolt is still paired with the controller and steps A and B need to be repeated again)
This means the Digital Deadbolt is ready to be paired. To do that, the controller must be set on the paired
mode. Then the above step 3 needs to be followed in the Lockwood Wireless Digital Deadbolt to include it
to the new Z-wave/ZigBee network.
NOTE: Lockwood Wireless Digital Deadbolt has been tested successfully with some Z-Wave/ZigBee
controllers. Please ask your Home Automation Z-wave/ZigBee controller retail vendor or dealer for
more information about integrations with a specific controller.
**Network Module Setting
English
Enable
Disable
Join the network
Exit the network
**This function appears only
with RF network module
Note: If the lock is connected to a network
controller, it is recommended that it is
programmed through the centralised
interface (PC or hand-held device) to ensure
communication between the lock and the
controller unit.